Whaler Restoration – Rub Rail Part #2

With the bow light installed, finishing the installation of the rub rail involved drilling a hole into the hull to run the power cable from under the rub rail to inside the hull.  I used some 4200 to seal the hole inside the hull, then installed a stainless clamshell to finish that job. I then squeezed in the rubber insert around the entire length of the hull and over the wires, hiding and protecting them. 4 large screws and more 4200 (not pictured) attached the rubber insert to the stern.  I’m very happy with the look of the all white rub rail.  Very clean!

Facebook Comments